Reclamation of embankments and drainage canals
THE LAND RECLAMATION CONSORTIA COME OUT IN TEAMS AND NEED TO CLEAN THE RIVER BANKS ON BOTH SIDES
The problems that arise when using traditional tractor configurations are
the following:
• Very narrow embankments, so it is impossible to turn around
• Very high wheel of the usual tractor that limits visibility
• After clearing the embankment, it is necessary to drive in reverse gear when visibility is poor and the operator’s position is difficult
• The steering positioned at the front; driving in reverse creates the risk that a rear wheel may fall off the embankment with consequent safety problems for both the operator and the vehicle
• The set up weight of the tractor is quite high, so it is necessary to wait for the ground to dry out in case of bad weather
PASSAGE ON THE CREST OF THE EMBANKMENT WITH FRONT AND REAR MULCHER SET-UP
WHAT ARE THE ADVANTAGES OF USING BETTER?
- VISIBILITY of tools and the ground to be worked.
- OPERATOR SAFETY, with 4 steering wheels where the front wheel passes, the rear wheel also passes through and vice versa. In tight spaces this is crucial
for safety. - Thanks to the extreme MANOEUVRABILITY AND THE 4-WHEEL STEERING when the embankment allows it, it is possible to turn around, then return to standard driving and also work the embankment on the
opposite side that had not been previously done. - The WEIGHT OF THE TRACTOR IS DEFINITELY LOWER, thanks to the use of 500 mm wide tires with minimal ground compaction. It is possible, in case of bad weather, to start work earlier than with traditional tractors.
- Should you need to reverse, you can rotate the driver’s seat 180° and DRIVE IN TOTAL SAFETY.
- Being equipped with INDEPENDENT STEERING WHEELS, you can decide to steer one axle and/or the other at will. In the case of complex situations on the embankment, it is possible to crab out, or rotate only one axis to move.
- The HYDROSTATIC TRANSMISSION allows the implements to be kept at fixed speed, regardless of the forward speed, by adjusting the Diesel engine with the manual throttle, thus ensuring the optimal work of the implements
without any drop in Diesel performance.
CLEANING THE EMBANKMENT BOTH ON THE RIGHT AND ON THE LEFT
WHAT ARE THE ADVANTAGES OF USING BETTER?
For CLEANING SLOPE ARGES with conventional tractors it is unsafe to work from the side, so the team must use edge cutters with a clearly lower output in terms of the area mowed in a single pass (1.20 – 1.50 metres against 2.50 – 4.80 metres).
DEFORESTATIONOF CERTAIN AREAS
WHAT ARE THE ADVANTAGES OF USING BETTER?
areas where the vegetation is very thick, it is possible to equip the machine with a FOREST MULCHER, and rotate the driver’s seat to work safely even on slopes.